Short Stories

About

Monday, May 30, 2016

Electrical: Adding a Switch and Lights

I needed more lights in my basement, so I added lights and a switch. Let me be clear, I'm not an electrician.
I have a garage with a single light that is woefully insufficient. Currently I have to stumble into the garage, hands outstretched, trying not bump into anything, and hoping I can find the string for the single light.

I added a second light and a wall switch at the door. The wall switch will power both garage lights and the adjacent bathroom (A bathroom is generous. It's a room with a toilet awkwardly mounted). I also added junction box at the switch, at the wall where my power wire splits between lights and switch, and at the bathroom in case I ever renovate it. Anytime you cut wires, you need a junction box with cable clamps. The cable clamps ensure you can't pull on the wire and loosen the connection. If you do have a short, the box contains any sparks. Any splices require a junction box. This isn't just safety, this is a code requirement.
Junction boxes house any and all wire splices. Any splices need to be capped.

Since there is no ceiling, it was easy to trace the wires back to where they entered the garage.
I figured out which breaker controlled the lights after flipping through all the breakers. If the previous owners didn't label the box well, think about relabeling. It saves you a lot of headache with work like this. NEVER do electrical work without checking and then double checking that the wires are NOT live.

To get enough length of wire for the junction box, I ran a new wire from the junction box to the first light. I cut the existing wire at the junction box with enough length to splice.

I bought cheap light fixtures and boxes. The plastic boxes nail to the joists and the fixtures are a single bulb base with dual connections that allow daisy chaining of multiple lights. The second light then connections to the bathroom light. I stapled the wiring to the ceiling joists every so often to secure it. Do not staple through the wire.
Light base and box.
The light base allows a chain of lights to be connected.


The light switch splices into the power wire before the first light, interrupting the circuit. The box for the switch is nailed to a stud and the paneling cut out for the box. I ran wiring from my junction box along the bottom of the joists and down the wall that would house the switch. The switch is spliced into the black (power) wire. The switch box is nailed to an adjacent stud.
Light switch box.

I also ran a wire to the bathroom area that terminates in a junction box. The bathroom is unfinished, but if I ever finish it, I now have power run so I can put the fixture on a separate switch wired from this junction box. This power is spliced in before the switch. If I were to splice it in after the switch, that switch would turn power to the bathroom on and off, which isn't optimal.

I added wire caps to all wire connections and the loose wires at the bathroom junction box. All wire caps were then taped to ensure they stay in place.
Tape the wires together to prevent them from pulling apart.
Add a wire cap to the wires. Make sure it's the right size.
If it's too small it will not stay on or connect the wires properly.
Tape the wire nut to the wires. It's easy insurance.

Once the work was done I flipped the breaker back on and the lights and switch work. Now I don't have to wander into a dark garage.

I'm not an electrician. Any action you take based on my instruction you do so at your own peril. I claim no responsibility.

No comments:

Post a Comment